SENSOR FAULTS DIAGNOSIS IN AIRCRAFT LATERAL FLIGHT CONTROL USING MODEL BASED APPROACHES
Keywords:
Flight Control, Fault Detection, Fault Isolation, Model Based ApproachesAbstract
In this paper, sensor fault detection and isolation schemes are proposed. Fault detection and isolation techniques are used in fail safe control systems such as aerospace. In these systems, failures can cause to arise undesirable results. Using model based approaches, sensor faults can be detected and isolated. To detect sensor faults, some kind of observers can be used while isolating the faulty sensors, some kind of schemes can be used. In this study, sensor fault detection and isolation are obtained on an aircraft lateral flight control system using model based approaches. Full Order Observer and Reduced Order Observer are used for sensor fault detection while Dedicated Observer Scheme (DOS) and Generalized Observer Scheme (GOS) are used for sensor isolation. Fault detection and fault isolation methods are analyzed and compared with each other.
Downloads
References
[2] Demirci U, Kerestecioğlu F. (2005) “Fault Tolerant Control with Re-Configuring Sliding-Mode Schemes”, Turk J Elec Eng & Comp Sci, 13, 175-188.
[3] Göksu Ö, Hava A.M. (2010) “Experimental investigation of shaft transducerless speed and position control of ac induction and interior permanent magnet motors”, Turk J Elec Eng & Comp Sci, 18, 865-882.
[4] Cai S, Kebairi A, Becherif M, Wack M. (2010) “Fuzzy logic and observer based fault detection for a mechatronic actuator”, Conference on Control and Fault-Tolerant Systems (SysTol); Nice, France, pp. 299 – 304.
[5] Dal M, Teodorescu R. (2011) “Sliding mode controller gain adaptation and chattering reduction techniques for DSP-based PM DC motor drives”, Turk J Elec Eng & Comp Sci, 19, 531-549.
[6] Aksoy S, Mühürcü A. (2011) “Induction motor, state estimation, extended Kalman filtering, recurrent neural networks”, Turk J Elec Eng & Comp Sci, 19, 861-875.
[7] Aydeniz MG, Şenol İ. (2011) “A Luenberger-sliding mode observer with rotor time constant parameter estimation in induction motor drives”, Turk J Elec Eng & Comp Sci, 19, 901-912.
[8] Leblebici T, Çallı B, Ünel M, Sabanovic A, Bogosyan S, Gökaşan M. (2011) “Delay compensation in bilateral control using a sliding mode observer”, Turk J Elec Eng & Comp Sci, 19, 851-859.
[9] Shoukry I, Kunt E.D., Sabanovic A. (2012) “Action-reaction based parameters identification and states estimation of flexible systems”, Turk J Elec Eng & Comp Sci, 20, 47-56.
[10] Gürcan R, Kartal R.M. (2012) “Observer path design by imitation of competing constraints for bearing only tracking”, Turk J Elec Eng & Comp Sci, 20, 1160-1174.
[11] Ammar N. (2000) “Robust Fault Detection by Simultaneous Observers”, MSc, Bilkent University, Ankara, Turkey.
[12] Stevens B.L., Lewis F.L., (1992) “Aircraft Control and Simulation”, New York, USA: Wiley.
[13] Blanke M, Kinnaert M, Lunze J, Staroswiecki M. (2003) “Diagnosis and Fault-Tolerant Control”, Berlin, Germany: Springer-Verlag.
[14] Solak E. (2001) “Observability and Observers for Nonlinear and Switching Systems”, PhD, Bilkent University, Ankara, Turkey.
[15] Mclean D. (1990) “Automatic Flight Control Systems”, UK: Prentice-Hall.
Downloads
Published
How to Cite
Issue
Section
License
The manuscript with title and authors is being submitted for publication in Journal of Aeronautics and Space Technologies. This article or a major portion of it was not published, not accepted and not submitted for publication elsewhere. If accepted for publication, I hereby grant the unlimited and all copyright privileges to Journal of Aeronautics and Space Technologies.
I declare that I am the responsible writer on behalf of all authors.